Description: Adhezive for polystyrene plates. Fiber reinforced polystyrole

Caracteristics: •best adherence, •facile processing •high resistance, •high flexibility Composition: cement, minerale addition, polymers to improve the adherence , plastifiers.

Domain of use: For cover (filling) expanded and extruded polystyrene plates, both inside and outside the buildings. Using FIBER REINFORCED POLYSTYROLE it result high flexibility surfaces and improved adherence between of the glass fiber net and the polystyrene plate.

Preparation of working surface: The support surface must be clean, hard, without detached areas and good reinforce, after an aging time of at least 28 days. The surface must be controlled with the hammer, if its resistant is sufficient to support plating.

Application mode: Used utensils: •pail •mechanical or manual stirrer •trowel •6 x 6 mm to 12 x 12 mm toothed smoother •carpenter introduce the powder in water and start to mix. Both, the recipient and the used water must be clean. It will be recommended to mix one time, just the quantity of material needed one hour. The stirring will be intensively, preferably mechanical (to attach an axle with palettes to an electrical piercer), to obtain a cream–mix, homogenous, easy to be processed. After waiting 10 minutes to fulfill the chemical reactions, it will be stirred intensively again.

24 hours after apply the thermal and phonic insulate plates, cover the polystyrene plate or the rigid mineral fiber plate with polystyrene adhesive with reinforcing fibers, using a smoother with 6 x 6 mm – 10 x 10 mm teeth. Put the paste on the polystyrene surface, spots in equal distances of 15 – 20 cm and stripes 3 – 4 cm breadth on the edges. The polystyrene plate will be pressed on the insulating surface. The straight surface will be obtained pressing more surface plates, using a long wooden or metallic jointing rule. The rigid mineral cotton will be applied on the surface with a polishing device with tooth of 8 x 8 mm – 12 x 12 mm. Begin from the surface upside a glass fiber net covered with plastic material, will be rewind, the orifice are 5 x 5 mm - 10 x 10 mm and press in the existent stripes. With the right side of the smoother introduce uniformly inside the adhesive, until the reinforce fiber will be completely covered from the adhesive (min. layer thickness 3 mm). The net rows superpose on section of at least 10 cm.

Recomandations: After minimum 72 hours, the surface may be covered or finished with all the known materials, without organic solvents. The recommendation for expanded polystyrene insulate is a cover with plaster ornaments, as last finish. .

Storage: In dry places, in closed state, on wooden pallets.

Packing: In 25 kg bags.

Specific consumption: II. phase - cover the stuck plates: with the polish device of 6 x 6 mm 2,5 – 3,5 kg/m2